More electrical problems
Thread Starter
|
Trailering
Joined: Sep 2022
Posts: 23
Likes: 1
From: Logandale
More electrical problems
So I fixed my blinkers thanks to an earlier thread, and my truck was working fine. Then when I go out in the morning, my turn signals aren't working. The hazards are working though. When I try to use the turn signal nothing happens, not even the indicators in the dash turn on. I tested the flasher and it's fine, but I'm not hearing a ticking in it like normal, so I'm guessing the issue is somewhere in the circuit before the flasher. I took the turn signal switch out and cleaned it, and it didn't look like anything was wrong. Fuse looks fine, and I tried cleaning the fuse connections, but still nothing. No dash lights ate working either, not sure if that helps. Sorry for the long explanation and asking stuff so much, you guys are just so helpful.
Thread Starter
|
Trailering
Joined: Sep 2022
Posts: 23
Likes: 1
From: Logandale
Checked those sockets, seemed good, but thanks for the idea. I just tested the blue wire that runs to the switch, and it isn't getting power, but there is power to the flasher. So I'm pretty sure it's that circuit with the blue wire in between the flasher and the switch because the flasher is good. So does anyone have any insight on how to go about that?
Laughing Gas
Joined: Nov 2013
Posts: 1,207
Likes: 60
From: S.E. Louisiana;so far USA
It's likely a sad connection somewhere. Vehicles with outside storage often have them. If you have a wiring diagram, you may have to take a test light or voltmeter and "trace out" the circuits which affect the turn signals.
Thread
Thread Starter
Forum
Replies
Last Post
Alexis Garcia
1999 - 2003 7.3L Power Stroke Diesel
2
Sep 23, 2022 09:06 AM
f350hammer
1994.5 - 1997 7.3L Power Stroke Diesel
4
Feb 9, 2014 08:08 AM
Agemenon
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
6
Dec 18, 2007 09:58 AM
