Where do i get the tool to disconnect the hydraulic line from the slave cylinder on my 1995 F150? Do i need the tool or would i be able to make a tool? THanks

 

I used a piece of sheet metal rolled up to fit around the coupler and depress the fingers inside. I have also used a pliers, but the sheet metal works better, especially when the plastic starts to deteriorate. (WHY THE F IT IS PLASTIC I DON"T KNOW!!!!) The dealership, or maybe even a parts house should have one, too. It is a cheap little plastic deal.

 

is it the same as the fuel filter tool? if so i have a set. thanks

 

It may very well be. It may work for it, too. Don't know for sure though. If not, it can be done with 2 screwdrivers, that's how most people do it, I know. Easier than pliers and you don't need to have sheet metal around.