Help needed on Brake Installation
Jan 19, 2020 | 03:40 PM
Thread Starter
|
New User
Joined: Jan 2020
Posts: 4
Likes: 0
Help needed on Brake Installation
How do I get the marked area further out so i can put the spacers and the snap ring back on? I’m spinning it pushing it, twisting it but I can‘t get it further out... the other side was fine and it was in position when i removed everything,
Thanks for your help.
Eike
Jan 19, 2020 | 06:15 PM
Joined: Jun 2015
Posts: 12,818
Likes: 2,431
Are you saying the axle shaft isn’t out far enough for you to install the clip? Pull on it or push on the u-joint from the back side.
Jan 19, 2020 | 06:19 PM
Thread Starter
|
New User
Joined: Jan 2020
Posts: 4
Likes: 0
Yes, I’m trying to push but it’s not coming further out even though i can see on the backside that it should be out about an 1/8 of an inch more.
Jan 19, 2020 | 06:28 PM
Joined: Jun 2015
Posts: 12,818
Likes: 2,431
What was the “everything” you removed? If only the hub/ rotor the. Nothing should be holding the axle from coming further out.
Jan 19, 2020 | 06:33 PM
Thread Starter
|
New User
Joined: Jan 2020
Posts: 4
Likes: 0
Yes hub and rotor, i know it shouldn’t, but i can’ get it out any further...
Jan 19, 2020 | 06:44 PM
Joined: Jun 2015
Posts: 12,818
Likes: 2,431
What else needs to go on there? It appears to be out far enough to install the “c” clip.
Jan 20, 2020 | 07:52 AM
Thread Starter
|
New User
Joined: Jan 2020
Posts: 4
Likes: 0
The needle thrust bearing and the bearing spacer
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BobQPublic
1999 - 2016 Super Duty
8
May 2, 2018 10:18 AM
Scndsin
Escape & Escape Hybrid
14
Nov 19, 2014 07:21 AM
wfowfo
1966 - 1977 Early Broncos
9
Mar 5, 2013 10:07 PM
tommyl
1999 - 2003 7.3L Power Stroke Diesel
2
Oct 1, 2012 07:13 PM
plgebbia
1999 - 2003 7.3L Power Stroke Diesel
6
Apr 22, 2011 07:30 PM
