Rabs Light
Thread Starter
|
New User
Joined: Sep 2003
Posts: 2
Likes: 0
Rabs Light
HELP. OUR 92 RANGER,2WD,AUTOMATIC,4.0 LITER V-6 RABS LIGHT STAYS ON. THE BRAKES WERE ADJUSTED AND THE SPEED SENSOR WAS REPLACED. ANY SUGESSTIONS WHERE TO GO FROM HERE WOULD BE GREATLY APPRECIATED. I TRIED THE STICKY INFO AND ONLY GOT AN EMPTY FILE WHEN I DOWNLOADED THE RABS PINPOINTS.
Post Fiend
Joined: Dec 2001
Posts: 10,562
Likes: 4
From: South Jersey
Welcome to FTE!!!
You need to pull the code, try the link again it worked for me. If it still gives you problems email me and I'll send it to you, please remind me what you need.
You need to pull the code, try the link again it worked for me. If it still gives you problems email me and I'll send it to you, please remind me what you need.
Last edited by Ken00; Sep 30, 2003 at 02:27 PM.
Thread Starter
|
New User
Joined: Sep 2003
Posts: 2
Likes: 0
RABS LIGHT
WE CHECKED EVERYTHING LISTED UNDER THE PULLING THE RABS CODE. WE CONNECTED A GROUND WIRE TO THE UNDER DASH TEST MODULE AND WE DIDN'T GET ANY FLASHES. BLED THE BRAKES AGAIN, THE RAB LIGHT AND BRAKE LIGHT BOTH WENT OUT THEN CAME ON AGAIN WHEN THE BRAKE WAS APPLIED. BACK TO SQUARE ONE WITH BOTH LIGHTS STAYING ON. WE ALREADY REPLACED THE SENSOR. ANY SUGGESTIONS WOULD BE GREATLY APPRECIATED.
Posting Guru
Joined: Dec 2002
Posts: 1,428
Likes: 0
From: peoria, az
So far I've only seen 2 things that cause this. Are both your lights on ( brake and RABS)? Check your front pads. If they are worn too much it will turn on the lights. If pads are O.K., replace the valve.
