timing

Reply Subscribe

Thread Tools

Search this Thread

Sep 5, 2018 | 04:34 PM

gary's1950F1

Thread Starter

Senior User

Joined: Jul 2015

Posts: 109

Likes: 1

From: Brule Wisconsin

timing

I put a HEI distributor in my 352. Do I need to change spark plug gap or timing. Right now plugs are gap is at 45 and timing is 10 degrees btdc.

Sep 5, 2018 | 05:00 PM

85e150

Super Moderator

Joined: Apr 2004

Posts: 34,510

Likes: 2,823

That sounds ok, how does it run? I think the OEM gap was in the .35 range. Stock timing may have been 6 degrees, but there are several reports of better running at 10. My own 289 ran better at about 10 vs. 6. Stand by, someone who actually knows something will be by.

Sep 5, 2018 | 06:31 PM

gary's1950F1

Thread Starter

Senior User

Joined: Jul 2015

Posts: 109

Likes: 1

From: Brule Wisconsin

It seems to start and idle ok but when I punch it from an idle it back fires. Its fine if the rpms are up then punch.

Sep 5, 2018 | 06:38 PM

ford390gashog

Fleet Owner

Joined: Jan 2004

Posts: 26,007

Likes: 575

From: Brentwood,CA

If it backfires that's an issue. Does your timing light have adjustments for timing? Set it to ten and look at the mark on the dampener. It may have slipped. Also what's your total timing?

Sep 5, 2018 | 08:58 PM

gary's1950F1

Thread Starter

Senior User

Joined: Jul 2015

Posts: 109

Likes: 1

From: Brule Wisconsin

No adjustments on the timing light.

Sep 6, 2018 | 10:22 AM

'65Ford

Cargo Master

Joined: Jan 2016

Posts: 2,674

Likes: 376

Won't hurt to graph your timing curve. Measure the advance at initial with vacuum disconnected and plugged (if you have vacuum advance) and then in 500 rpm increments until you hit maximum advance. Then graph it again with vacuum connected.

I kinda doubt it's your timing curve though it may be ignition related...bad coil, for instance. Or maybe you have something loose in your distributor.

Is it back firing (up through the carb) or after firing (down through the exhaust)?

Sep 15, 2018 | 08:25 PM

99f350sd

Lead Driver

Joined: May 2003

Posts: 9,303

Likes: 48

From: Lyndonville, Vermont

If its through the carb you may have an accelerator pump issue...Check the spray. Sometimes they stick sometimes they wear out...A little oil on the pin sometimes.