RemoveT98
Thread Starter
|
Mountain Pass
Joined: Jul 2015
Posts: 182
Likes: 0
From: Queensland, Australia
RemoveT98
Hi, trying to remove T98 off the engine.
Both on the engine crane at the moment. Undone the four bolts.
Started to seperate, say an inch. Real difficult to pull out further.
Theres nothing else I need to do?
Thanks,
Both on the engine crane at the moment. Undone the four bolts.
Started to seperate, say an inch. Real difficult to pull out further.
Theres nothing else I need to do?
Thanks,
Lead Driver
Joined: Dec 2012
Posts: 9,696
Likes: 823
From: Wentzville, MO
Just shake the tranny up and down while pulling it away from the engine. It helps if the engine is on the floor and stationary. Probably the input shaft or clutch release bearing (aka throw out bearing) is hung up.
Thread
Thread Starter
Forum
Replies
Last Post
Eallend7
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
16
Nov 19, 2012 05:48 AM
TrajansDaddy
1983 - 2012 Ranger & B-Series
6
Mar 7, 2009 02:01 PM
