Rear ABS sensor issue
Thread Starter
|
Logistics Pro
Joined: Aug 2007
Posts: 3,974
Likes: 18
From: Millersburg, OH
Rear ABS sensor issue
A week ago I stop at a light and the ABS light came one. On TorquePro wheels 2 and 4 just showed 0 as the speed all the time. Everything I found lead me to believe it was the rear ABS sensor that was bad. So I bought a new one and when I took off the pig tail the connector on the inside pretty much came completely apart. So I bought a new pigtail as well. After getting that and the new sensor in I still have the same issue.
My question is before I throw any more parts at it how do I go about diagnosing the issue? Anyone know what I should be getting at the connector end on what wire? At least if determine this I can eliminate everything up to the sensor.
According to Oasis the rear end was totally rebuilt so I'm hoping something did go wrong and the tone ring (and more) is shot.
My question is before I throw any more parts at it how do I go about diagnosing the issue? Anyone know what I should be getting at the connector end on what wire? At least if determine this I can eliminate everything up to the sensor.
According to Oasis the rear end was totally rebuilt so I'm hoping something did go wrong and the tone ring (and more) is shot.
Thread Starter
|
Logistics Pro
Joined: Aug 2007
Posts: 3,974
Likes: 18
From: Millersburg, OH
Well I just went out and reread the codes and I see a C1145 which is the RF ABS sensor! I swear that wasn't there before I start this whole process. Either way it looks like I'm an idiot and been chasing the wrong problem!
I would still like to know why TorquePro shows wheels 2 and 4 with no speed?
I would still like to know why TorquePro shows wheels 2 and 4 with no speed?
Postmaster
Joined: Aug 2015
Posts: 3,910
Likes: 18
From: NW IA
Well I just went out and reread the codes and I see a C1145 which is the RF ABS sensor! I swear that wasn't there before I start this whole process. Either way it looks like I'm an idiot and been chasing the wrong problem!
I would still like to know why TorquePro shows wheels 2 and 4 with no speed?
I would still like to know why TorquePro shows wheels 2 and 4 with no speed?
Thread Starter
|
Logistics Pro
Joined: Aug 2007
Posts: 3,974
Likes: 18
From: Millersburg, OH
Well I know why the RF ABS sensor was giving an error. Looks like new dust shields and new brakes are in order. I was able to tape up the ABS wire with some Super 88 and the ABS light is finally out.
Thread
Thread Starter
Forum
Replies
Last Post
