1987 - 1996 Ford trucks, parts for sale and wanted.
#31
[QUOTE=mmyjak;17828265]I'm new here. I hope this is the right place in the forum to ask. I need to replace the rear tubular bumper on my '94 Lightning after a sizable oak tree jumped in front of rearward-launching truck.
I under Smittybilt was the original manufacturer. Nowadays they appear to be Jeep-centered. So can anyone point me in the right direction find a replacement? I'm not sure even where to begin to restore this Lightning... but I'd sure like to try. So maybe with your help I can! :-)
Thanks for any advice you can provide -
Michael
Check out lmr.com good place to start if your serious
I under Smittybilt was the original manufacturer. Nowadays they appear to be Jeep-centered. So can anyone point me in the right direction find a replacement? I'm not sure even where to begin to restore this Lightning... but I'd sure like to try. So maybe with your help I can! :-)
Thanks for any advice you can provide -
Michael
Check out lmr.com good place to start if your serious
#32
Found one in a wrecking yard
#33
87-91 Driver side and passenger side doors
Hey y’all I’m am searching for driver side and passenger side doors preferably manual windows etc. for an 89 Ford F-250 custom 87-91 doors will work looking for them relatively close so southern Georgia
Thanks y’all ,
Joah P.
Thanks y’all ,
Joah P.
#34
#35
Bull bar
I am in east TN between Knoxville and Bristol. I am in search of the Bull bars or push bar that came on the obs. I’ve seen them on 87-91 and 92-97 but can’t seem to find one for sale. I would also be interested in a set of bumper guards that were really common on the Bull nose 80-86 but I have seen trucks with those on the obs
#38
E4OD Transmission
Hey guys,
I'm looking for an E4OD Transmission to mate with a 302. Pretty sure the bellhousings match for the 300, 302, and 351. It's going into an old '87, so I might need a wiring harness too. If ya got one let me know. I'm in the north Mississippi area. If anyone knows anything about doing this swap let me know.
Thanks,
Henry
I'm looking for an E4OD Transmission to mate with a 302. Pretty sure the bellhousings match for the 300, 302, and 351. It's going into an old '87, so I might need a wiring harness too. If ya got one let me know. I'm in the north Mississippi area. If anyone knows anything about doing this swap let me know.
Thanks,
Henry
#39
E4OD Transmission
Let the bidding BEGIN! and may the odds be ever in your favor JKJK
#40
I have a 89 300 efi is it the same?
#41
#42
#44
#45
See this:
https://www.ford-trucks.com/forums/1...l#post13333670