I am in the Eastern Panhandle of WV looking for a gauge cluster from a 92 or 93 F series with a tachometer for a gas motor. Also looking for a dash bezel with cutouts and mounts for twin tanks and auto 4X4 switch, and a 78" bed without rust. willing to travel up to 100 miles.

 

Have real nice set of hubcaps, Make offer. Buyer pays shipping

 

Giving up on my project build. I am going to be leaving for military obligations this month on the 21st. Have a 95 f250, auto, 2wd. interior is basically gutted carpet, door panels, headliner. the engine is halfway disassembled.
Have a bunch of good performance parts I was gonna throw at it to make a nice cruiser/ weekend racer.
Holley hp efi kit, spark controller, coil and dual sync distributor
rhs cylinder heads screw in rocker studs, full roller comp cams rockers with flotech mid length headers.
holley ri ram intake with 102mm throttle body and sensors
scat 3.85" crankshaft
scat rods/ speedpro pistons
cheap cvf racing ebay electric water pump
intake gasket, mls head gasket, timing cover gasket set.

truck has a cheap tach and an electric fan installed just needs to be wired up. have the relay wiring kit for it.

want $4000 for the parts. if you want the truck too Ill throw that in for free. needs to be towed.

 

I dont know if you have found resolve for your request but I have a 95 f250 long bed regular cab dual tanks in the hunter green if you want it. located near Austin Tx though... Motor is halfway disassembled because I was trying to build a 393 stroker but ran outta time. leave for military obligations this month. looking to get rid of it asap.

 

Did an engine swap. Have lots of 1989 F250 351 parts. List consists of serpentine belt brackets & tensioner, engine mount frame ears, C6 trans fluid cooler, assorted brackets for engine, radiator support, ac compressor, alternator, starter, distributor, etc. PM me for what you are looking and I will see if I still have it.

Matthew Hintlian
mhintlian@yahoo.com

 

Looking for the dash mounted overdrive cancellation button or wiring diagram of the 5 wire device to replace with a momentary over the counter switch.
It's for a 91 E350 but I believe the F350 used them as well.

Thanks in advance.

 

Looking for (2) F250 Alcoa center caps.

 

Looking for PMF 2.25 reverse shackle kit, preferably with tow hitch.

 

Does anyone have a set of gray power window door panels in good shape in the Ohio area?

 

Hello, i have a maroon long bed srw with dual tanks for sale. Very very clean bed. 9.8 out of 10. Located in Central California. Send pm

 

Hi there, I am brand new to this forum, although I've read a lot of posts before joining.

I can not find a 4spd shift boot for my gen 8 F-150 anywhere. I see a lot of 5spd boots for sale all over the place, but they will not fit the stick on my T18 4 on the floor.

I threw the old one away during my interior gut, assuming it would be easy to find, so I don't have the part number for it either. Can anyone assist?

Thanks in advance for any help!

 

Hey all! Looking for matching body parts for my truck. 97 F250 colors E4/YZ Vermillion Clearcoat/Oxford White. Help in any direction would be much appreciated!

 

Which body parts do you need? They are out there...you just need to trawl the classifieds and junkyards daily and you will find it in a matter of months.

 

Thanks for the fast response! Mainly the drivers side fender. Found one in Tennessee but they weren't trying to ship it.

 

Check this one out https://washingtondc.craigslist.org/...204270424.html