Carburetor studs
Thread Starter
|
New User
Joined: Mar 2017
Posts: 24
Likes: 0
Carburetor studs
Anyone ever have an issue with pulling a 460 and c6 transmission using a carburetor plate with the cherry picker? My studs don't look very beefy and I'm concerned it won't hold the weight.
Cargo Master
Joined: Dec 2015
Posts: 2,549
Likes: 331
From: Harned, Ky
It'll surprise you what four 5/16 studs will hold up.
Which is stronger, four 5/16 studs on the intake or two 3/8 bolts, one on each end of the engine, when pulling the engine and trans probably 80% of the weight is on the one back bolt.
Which is stronger, four 5/16 studs on the intake or two 3/8 bolts, one on each end of the engine, when pulling the engine and trans probably 80% of the weight is on the one back bolt.
Thread
Thread Starter
Forum
Replies
Last Post
sum_weirdo
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
10
Jun 23, 2009 12:30 AM
vaughn1977
1987 - 1996 F150 & Larger F-Series Trucks
6
Jan 26, 2007 10:23 AM
know_fear
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
8
Apr 24, 2006 10:07 AM
stuperscout
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
1
Jun 23, 2003 10:49 AM
