Bullydog chip just installed
Thread Starter
|
New User
Joined: Aug 2003
Posts: 2
Likes: 0
From: 5 acres SE of Denver
Bullydog chip just installed
I just installed a four bank Bullydog. I cleaned the contacts on the computer for at least 20 minutes including light scraping with a small screwdriver. However, I don't notice any power difference between any of the four settings when I rev it up and get the Turbo around 20psi. This is my first chip so I'm not sure what to expect.
I also installed 4 inch exh and rapid flow intake which seems to have made a difference aside from the chip.
Am I missing something?
Thanks for your comments.
mj
I also installed 4 inch exh and rapid flow intake which seems to have made a difference aside from the chip.
Am I missing something?
Thanks for your comments.
mj
Freshman User
Joined: Jul 2003
Posts: 30
Likes: 0
From: Lancaster, SC
Bullydog chip just installed
I installed the same chip with a rotating switch. I feel a BIG differance between the settings. In fact the idle jumps up a couple hundred rpm by flipping the switch. If I am at 35 mph and flip the switch it will gain at least 5 mph with the same foot pressure.
Thread Starter
|
New User
Joined: Aug 2003
Posts: 2
Likes: 0
From: 5 acres SE of Denver
Bullydog chip just installed
Well... I had the switch assembly plugged in wrong. They way the connector is designed it wasn't hard to do.
Anyway, what a difference... WOW.
mj
Anyway, what a difference... WOW.
mj
