lots of folks have asked me over the years what actuators I used or what the specs were...

well... while looking for something else I found these pages that I'd gotten from Warner (they make them) the one I'm using is the same as D24-05B5-04... 4" stroke 24vdc

hope this helps some of you tilt front end guys...

john

http://jniolon.classicpickup.com/actuators1.pdf

 

Thanks John. Those look nice. Are you using 24v actuators on a 12v system?

 

yep just run a little slower

j

 

Did the 12v version run too fast?

 

I never had the 12 volt... mine were given to me and 24 volt. the information I posted shows inch per second speeds

\john