1964 262 six
Thread Starter
|
Fleet Mechanic
Joined: Nov 2002
Posts: 1,643
Likes: 69
1964 262 six
I recently heard of this:
My name is Brent House and I am a hot rodder and I wanted to reach out to you with something I think you might be able to help me out with. I recently purchased a 1964 Ford F250 that has a running inline 262 cu in engine in it. I am pulling the engine, original transmission and Dana rearend and will be replacing it with a modern driveline and suspension. I am hoping you all can help me here. I understand the Ford 262 is a fairly rare engine that was only produced for 3 or 4 years up until 1964 or so. I do not need the engine, tranny or rear end anymore, but being a hot rodder I would hate to scrap a potentially scarce engine that someone may be interested in or need for their own project. Would you be willing to put the word out to see if there is any interest in this or at least let me know if I should just go ahead and scrap it as it is not worth keeping? I am not looking to really get anything out of it except to get these parts to somebody who could use them. I will be pulling the engine soon and I can provide any pictures of the engine or even a video of it running if need be. I live in the Seattle area but I would be willing to try and work with somebody to make the swap. I will try to hold off scrapping it until I hear back from you.
Thanks for your help in this.
Brent House bhouse46@hotmail.com
My name is Brent House and I am a hot rodder and I wanted to reach out to you with something I think you might be able to help me out with. I recently purchased a 1964 Ford F250 that has a running inline 262 cu in engine in it. I am pulling the engine, original transmission and Dana rearend and will be replacing it with a modern driveline and suspension. I am hoping you all can help me here. I understand the Ford 262 is a fairly rare engine that was only produced for 3 or 4 years up until 1964 or so. I do not need the engine, tranny or rear end anymore, but being a hot rodder I would hate to scrap a potentially scarce engine that someone may be interested in or need for their own project. Would you be willing to put the word out to see if there is any interest in this or at least let me know if I should just go ahead and scrap it as it is not worth keeping? I am not looking to really get anything out of it except to get these parts to somebody who could use them. I will be pulling the engine soon and I can provide any pictures of the engine or even a video of it running if need be. I live in the Seattle area but I would be willing to try and work with somebody to make the swap. I will try to hold off scrapping it until I hear back from you.
Thanks for your help in this.
Brent House bhouse46@hotmail.com
Thread
Thread Starter
Forum
Replies
Last Post
ftballman125
General Automotive Discussion
23
Jul 13, 2005 10:35 PM
