1958 F100.. Please help me find the seal between the rear fender and the wrap around utility bumber.
#1
1958 F100.. Please help me find the seal between the rear fender and the wrap around utility bumber.
Need the rubber seal between bumper and fender.
I am looking for the rubber seal that goes between the "utility" bumper and the rear fender. This is a Flare Side short bed. Also does anyone know if the big "Braton" bumper was an option or if that was an add on after delivery? Thanks for your help.
#3
McMaster-Carr
Here is a seal I seen on Mcmaster's site, Have not used it but when i seen it this thread came to mind.
Good luck in your search!
Here is a seal I seen on Mcmaster's site, Have not used it but when i seen it this thread came to mind.
Good luck in your search!
#4
Bill (Mr. NumberDummy).. Thank you for the verification on the bumper. The truck was purchased by the Forestry Department and they must have added the bumper.
Wally.. Thanks for the link to McMaster's site. I will check it out. You would think that little piece of rubber would be around somewhere. They sold more than one of these bumpers. Appreciate all the feedback.
Wally.. Thanks for the link to McMaster's site. I will check it out. You would think that little piece of rubber would be around somewhere. They sold more than one of these bumpers. Appreciate all the feedback.
#5
As mentioned, the bumper is aftermarket. I had the same bumper on my 1960 when I first took possession of the vehicle. The factory F-100 bumpers consisted of one of two styles depending on the bed option (Styleside or Flareside), were available in chrome or white, and did not have provisions for trailer hitch components.
#6
Thread
Thread Starter
Forum
Replies
Last Post
dylan1952
1948 - 1956 F1, F100 & Larger F-Series Trucks
7
05-22-2012 12:36 AM
grinnergetter
1973 - 1979 F-100 & Larger F-Series Trucks
24
04-24-2011 07:43 PM
daryl in kent
1967 - 1972 F-100 & Larger F-Series Trucks
5
01-30-2004 01:47 PM
tyminski
1948 - 1956 F1, F100 & Larger F-Series Trucks
10
03-31-2002 10:08 PM