Problem with 4x4
Thread Starter
|
New User
Joined: Aug 2003
Posts: 2
Likes: 0
From: Northern California
Problem with 4x4
Need some help with my '86 XLT 4x4. I have the touch drive and it has no problem going into 4x4 and it work's fine when it's in 4x4. But the problem is simply this: I can't get it -OUT- of 4x4 when it's in 4x4. I can it get out, but it's very tricky getting it out. I don't know if it's the relay switch or if it's the solenoid on the transfer case. Any help/suggestions would be greatly appreciated.
Thanks,
Thanks,
Thread Starter
|
New User
Joined: Aug 2003
Posts: 2
Likes: 0
From: Northern California
Problem with 4x4
We had to stop and hit the button and it still wouldn't change. So we would wait and hit it again, and then again and again and again. It's realy tricky to try to get back into two wheel drive. One time it got stuck in Low Range and we had a hard time getting out. It's real tricky to get back into 2WD. It's hard to explain, though, because it's been a while since we had it in 4WD, because once we got it in 2WD we decided not to put it back into 4WD until we figured out what was wrong. I own a '91 Ford Probe LX and I'm affiliated with a website that deal's with Probes, in which is very helpful so I decided to try and find a Bronco II forum and see if anyone could give me some pointers.
Thanks,
Thanks,
Senior User
Joined: Aug 2003
Posts: 164
Likes: 0
Problem with 4x4
i dont know if this will help but i have manual hubs and a manual xfer case on my b2 and still have to put it into reverse to get it out of 4 wheel drive. I guess it takes pressure off of the gears or something
