F350 blocks wanted
Thread Starter
|
Cargo Master
Joined: Feb 2011
Posts: 3,450
Likes: 13
From: Forest lake minnesota
F350 blocks wanted
Wondering if anyone has any F350 blocks and ubolts sitting around that they want to get rid of. Also does anyone know if I will have to change the drive shaft angle after the install..
Super Moderator
Joined: Aug 2008
Posts: 37,379
Likes: 1,863
From: Frederick, MD
I doubt you would need to change the angle for is one.
If you did notice something then a spacer for the carrier bearing would do the trick.
You may have to get a set from a junk yard. For the u bolts I would buy new.
If you did notice something then a spacer for the carrier bearing would do the trick.
You may have to get a set from a junk yard. For the u bolts I would buy new.
Senior User
Joined: Jan 2015
Posts: 186
Likes: 6
I see the F-350 blocks on ebay fairly often, but people are pretty proud of them. I got a pair from somebody on this forum who had removed them from his truck.
If you don't care about the built-in bumpstops or being original, there are other 4" block kits available from the aftermarket. I have one of those from Superlift if you're interested.
If you don't care about the built-in bumpstops or being original, there are other 4" block kits available from the aftermarket. I have one of those from Superlift if you're interested.
Senior User
Joined: Apr 2015
Posts: 481
Likes: 4
From: Cali
I see the F-350 blocks on ebay fairly often, but people are pretty proud of them. I got a pair from somebody on this forum who had removed them from his truck.
If you don't care about the built-in bumpstops or being original, there are other 4" block kits available from the aftermarket. I have one of those from Superlift if you're interested.
If you don't care about the built-in bumpstops or being original, there are other 4" block kits available from the aftermarket. I have one of those from Superlift if you're interested.
Senior User
Joined: Apr 2015
Posts: 481
Likes: 4
From: Cali
I couldn't get them out of my truck fast enough, not a fan on wheel hope and axle wrap. Nor do I like the look of a 3" rake.
That being said the Factory lift blocks are at least cast iron as opposed to cast aluminum aftermarket stuff.
That being said the Factory lift blocks are at least cast iron as opposed to cast aluminum aftermarket stuff.
Thread
Thread Starter
Forum
Replies
Last Post
