Heater help please
pedant
Joined: Jan 2008
Posts: 23,576
Likes: 38
From: EXTREME southwest CT
Okay, let's see if I can do this...
Here's the vacuum page from my '87 EVTM:
You see a single vacuum line controlling outside air, and dashed lines (cables) controlling the flaps in the ductwork.
Here's the electrical page from my EVTM:
The resistor is bypassed in 'High'
I have pic's of my plenum, control panel, etc... but I can't compress the pictures down to below 1.85M and still have enough detail.
I guess the cold left me with a foggy lens.
Here's the vacuum page from my '87 EVTM:
You see a single vacuum line controlling outside air, and dashed lines (cables) controlling the flaps in the ductwork.
Here's the electrical page from my EVTM:
The resistor is bypassed in 'High'
I have pic's of my plenum, control panel, etc... but I can't compress the pictures down to below 1.85M and still have enough detail.
I guess the cold left me with a foggy lens.
Thread Starter
|
Junior User
Joined: Jan 2013
Posts: 70
Likes: 0
From: Milan, Indiana
Thanks for the diagrams. Subford sent me a couple different ones as well I will put thise on the thread also. I think with these I have a good understanding of the system. Subford also confirmed that the little tank on the side of the heater box should be enough vacuum reserve.
Thread
Thread Starter
Forum
Replies
Last Post
dgeist
1968-Present E-Series Van/Cutaway/Chassis
18
Feb 11, 2021 08:21 PM
cr9c1
1968-Present E-Series Van/Cutaway/Chassis
4
Jan 1, 2007 01:57 PM
Dylansdad
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
3
Sep 8, 2004 01:34 PM
