49 F-1

All I need is the little barrels about 1" long and 1/4" diameter that fit inside the brackets that bolt to the cab floor. They are part of the seat forward/rear adjust mechanism as well as serving to stiffen the seat frame.

I wish I had a picture of them but they are just small cylinders, and if I recall correctly have groove machined around their midpoint. And I can't remember if 2 or 4 of them are required.

 

I don't remember if I ever responded to your PM to me about these parts. If I didn't, then I apologize. I don't have any of the seat parts you need.

Perhaps you can adapt something to work in their place???

 

I'm sure I could if I had a pattern to work from. Not a complicated part, just a metal dowel of the appropriate diameter cut to the appropriate length. Might be time to start working on that.