Torque converter bolt pattern

Reply Subscribe

Thread Tools

Search this Thread

Mar 30, 2014 | 10:27 PM

nintey4f150

Thread Starter

Senior User

Joined: Jul 2007

Posts: 248

Likes: 1

From: south jersey

Torque converter bolt pattern

I have a 94 f150 with a 4r70w Trans. I have noticed that there are different bolt patterns listed for the converter. Can anyone tell me which one I have?

Mar 31, 2014 | 07:41 AM

subford

Fleet Owner

Joined: Aug 2005

Posts: 23,667

Likes: 301

From: Easton,Ks

Were do you listing. As far as I know there is not a pattern, none listed in the shop manual. Just align the orange balancing marks on converter stud and flywheel bolt hole if balancing marks are present.
Torque the nuts to 27-46 N-m (20-34 lb-ft).

Mar 31, 2014 | 08:04 AM

nintey4f150

Thread Starter

Senior User

Joined: Jul 2007

Posts: 248

Likes: 1

From: south jersey

Searching for an aftermarket one. Some sites asked which bolt circle it it... 11.4 and I forget the other

Mar 31, 2014 | 09:16 AM

subford

Fleet Owner

Joined: Aug 2005

Posts: 23,667

Likes: 301

From: Easton,Ks

I thought you were asking about a torque sequence pattern and not a circle diameter.
I think all 4R70W torque converter bolt circle diameter are the same.
If you really need one I guess I could go out to the barn an measure one if nobody else posts it.

Mar 31, 2014 | 11:15 AM

nintey4f150

Thread Starter

Senior User

Joined: Jul 2007

Posts: 248

Likes: 1

From: south jersey

yea.. i just noticed there were 2 different sizes listed so it threw me off a little bit

Mar 31, 2014 | 11:35 AM

subford

Fleet Owner

Joined: Aug 2005

Posts: 23,667

Likes: 301

From: Easton,Ks

The studs on the torque converter are 11.5" across center to center of stud.
Could be the 11.4" but it looked 11.5" to me.
The outside of the torque Converter is about 12.75" across.