reverse sensors
Thread Starter
|
Freshman User
Joined: Feb 2011
Posts: 47
Likes: 0
reverse sensors
I put an aluminum flatbed/dump on my 2008 F359 4x4 single wheel. The bed hangs 5" beyond the rear bumper. It is also 12" above the sensors. The sensor goes off when I put it in reverse. Is there a range of detection or some way to adjust the range of the sensors so they don't "see" the rear of the bed? I was thinking of tilting the bumper down but afraid it may detect the ground (plus it will look stupid).
Thread
Thread Starter
Forum
Replies
Last Post
stv1991
1999 - 2016 Super Duty
0
Jun 6, 2015 07:14 AM
