will this work
Thread Starter
|
New User
Joined: Apr 2003
Posts: 8
Likes: 0
will this work
Have found a 89' intake and plenum off a GT Mustang. Will this work on my 94' F-150 5.0 rebuild without messing up the computer ? Also a set of 89' GT Mustang heads E7TE casting. Will they work? Any help is appreciated. Thanks, Rudy 94'F150(rebuid in progress)96' Cobra,2000 Expedition&2003HD truck l
Freshman User
Joined: Apr 2003
Posts: 45
Likes: 0
will this work
youve already got those heads on your motor, if its a 94 engine. and the manifold that is on your engine right now is actually a little better than the stock mustang manifold. i wouldnt take the parts from the mustang. id go with aftermarket stuff if you want more power.
Senior User
Joined: Feb 2002
Posts: 402
Likes: 0
will this work
adams right,actually the mustangers will run truck intakes because they flow better and are cheap.You'd be better off finding a set of gt-40p heads and intake off a 5.0 explorer.Sometimes you can find em at the junkyard for cheap and just re work the valve train.Your truck is speed density I would think unless it's a calif. model.check out http://www.50tech.com/ thet have a couple guys there who have done some modding on speed density and could help you out.
Bill
Bill
