'40-'47 cab floors
Thread Starter
|
Elder User
Joined: Sep 2002
Posts: 948
Likes: 0
From: McAlester, OK
'40-'47 cab floors
I'm just curious, but on the 1/2 ton pickups like everyone else has, on the floor right under the seat is there an an indention, like little canals that go to the center back? Maybe to a hole? Or is it just flat all the way around?
Clayton
Clayton
Admom
Joined: Feb 2001
Posts: 9,414
Likes: 201
From: Silver Springs
'40-'47 cab floors
Hey Clayton -
I'm not sure which part you're talking about, but maybe a photo of the back floorboard of our '41 cab will help. Mind you now, It hasn't been vaccumed in a loooooong time so the very back channel has some built up dirt & stuff.
I'm not sure which part you're talking about, but maybe a photo of the back floorboard of our '41 cab will help. Mind you now, It hasn't been vaccumed in a loooooong time so the very back channel has some built up dirt & stuff.
Thread Starter
|
Elder User
Joined: Sep 2002
Posts: 948
Likes: 0
From: McAlester, OK
'40-'47 cab floors
Ahh, yes that's good help. I was wondering if they were all the same. My Macs book shows a cab being assembled with the floor for the 3/4 and up trucks, yet the entire book doesn't really have anything but the 1/2 tons throughout the book. On the 3/4 ton and up the floor is just like the bottom of the gas tank that sits right under the seat. It has a channel design stameped in that part and doesn't have the ribs like yours. Thanks!
Clayton
Clayton
