Need to change out my front brakes soon and might as well grease the bearings while its apart. Ill have a check in the mail for you tomorrow snowseeker for whenever you get to spinning up another batch.

 

I will get around to making another batch some day soonish. I've had one letter on the counter for a few weeks now.

 

Hey whenever you get around to it is fine by me. It's awesome that you are willing to help out other members with them. Check is in the mail today.

 

Snowseeker, if you are still planning to build a couple more fittings I will take one. I will send the money out tomorrow.

 

I am, I have a few letters on the counter I need to fill so I will be making a run of them sometime here in the future.

 

I admit I didn't read every post, so I may have missed it... but I did see that you said your shipping was to lower 48 states only? What do you need to get a fitting to Alaska? zip 99705 for USPS

 

He shipped one to me in Canada.

I think I just paid $20 so that he wouldn't be short on shipping - he's done enough for everyone and I didn't want him to have to pay out of his pocket.

 

That as my plan, I just didn't want to make any assumptions.

 

Yes I can like mentioned. I remember the $20 was just a guess and after shipping the zerk I realized I was a bit heavy of the shipping estimate. But I know the shipping cost can vary quite a lot when going to Canada depending where in Canada it is going.

 

Thanks to Sean for getting the traveling zerk out to me.

Had everything apart for needle bearing lube and ESOF service so was an easy job. Took closer to 60 pumps to get some of the old grease to start coming out.

 

Andy,

Letter is going in the mail tomorrow for a couple of these. Thanks

It's a small world it seems. I stayed in Stevens Point years ago on a trip to Medford, WI. I have family in WI too just not quite that far north.

Travis

 

Can you add me to the list with the next batch of those zerk fittings? ...if you're still making them that is. Your PM inbox is full (probably full of grease).

 

Add to list as well please. If added, please PM me an addy so I can get money mailed out to you.

 

Guys, Andy (Snowseeker) is a pretty busy guy and typically has an overstuffed PM box here, his contact info is listed a few times throughout this thread but it is easy to get lost in the shuffle. Here it is, just send Andy your request, your address and some form of payment ( I used a bit of fuzzy math for my 2 zerks ) and be patient. Remember he isn't SELLING these zerk fittings, he is providing them to the members here as service and the money is to cover the shipping.

 

Tom,
Thanks for the info. I assumed after reading just a few of his posts that he was a very busy individual. I did fail in reading the entire thread and could have easily gleaned this information had I done that, so thanks for picking up my slack in that.

Andy, if you read this, thanks for the service you're providing to the members of this forum. I'll be sending you an envelope in the next few days, however, like Tom mentioned earlier, I'll be quite patient.

Love the interaction with y'all. Sure beats pirate4x4

Brendan