Readylift Block U bracket Question
Thread Starter
|
Senior User
Joined: Jun 2004
Posts: 176
Likes: 0
From: Rochester, NY
Readylift Block U bracket Question
Okay...im tickled i got my readylift 4" blocks for my 2011 250. But im having a bit of a problem with the huge *** U bracket.....it's so long, i cant get my deepwell sockets on the to tighten them down and my torque wrench on em. Should i just uit em shorter with a hacksaw or grinder? And what spec should I torque them to?
Posting Guru
Joined: Jan 2007
Posts: 2,364
Likes: 3
From: Gilbert Az.
Yep! Once you get them to the length nessecary cut them off at 1" or ^so past the pre tensioned nuts, the u-bolts should have come with a torque spec, if you can't find it I would check their website, a a last resort I would torque them to Ford specs they may be the same but the material could require more or less torque!
Jim & fat Monty
Jim & fat Monty
Thread
Thread Starter
Forum
Replies
Last Post
Chris55
Clutch, Transmission, Differential, Axle & Transfer Case
0
Mar 4, 2011 09:04 PM
