Sweltering September In Mississippi Thread
#16
Hey guys, we're back. Heavy duty road trip. Listened to my team spot the defending NCAA champs 14 points & then play down to the wire...
Dodged a major MHP bullet just outside of Hattisburg while trucking along @ 80+ on 49. ( I just wasn't paying attention & was following the leader) He nailed the Lexus that had just pulled around me and let the Edge wtih dealer tags in front go free too.
Lots of unpacking & decompressing to do as well as getting back into the routine.
Dodged a major MHP bullet just outside of Hattisburg while trucking along @ 80+ on 49. ( I just wasn't paying attention & was following the leader) He nailed the Lexus that had just pulled around me and let the Edge wtih dealer tags in front go free too.
Lots of unpacking & decompressing to do as well as getting back into the routine.
#18
an it's gotten quite warm again for a couple of days . 94 today an i was outside wiring up '2' motion light for the wife but by Thursday the temp is suppose to go down ??? i hope i hope my seat man will still be around in a week or so i would like to get started on the new covers. i can't make ctc but am going to emeral cruise this year
#21
It ain't swelterig now!
Yall can all thank me for the cooler temps. If I hadn't named this thread the way I did, we'd still be in the 90's.
Hope everyone has a good weekend, I'm starting a complete rebuild of Terri's Escape's front-end. Struts, CV-axles, control arms, and knuckle bearings. The lower temps will make it easier.
Yall can all thank me for the cooler temps. If I hadn't named this thread the way I did, we'd still be in the 90's.
Hope everyone has a good weekend, I'm starting a complete rebuild of Terri's Escape's front-end. Struts, CV-axles, control arms, and knuckle bearings. The lower temps will make it easier.
#22
#26
#29
Welcome to another working week.
I've got to run the Escape's knuckle/hub assy over to a front end place on 80 & have the bearings pressed this morning. Then the dealer to p/u an intermediate shaft assy. (not spared in the aftermarket) Then I can start putting it back together.
Hope everyone has a good week.
(Tim still waiting on that story)
I've got to run the Escape's knuckle/hub assy over to a front end place on 80 & have the bearings pressed this morning. Then the dealer to p/u an intermediate shaft assy. (not spared in the aftermarket) Then I can start putting it back together.
Hope everyone has a good week.
(Tim still waiting on that story)