Replacing balljoints..Steering knuckle stuck??
Thread Starter
|
Senior User
Joined: May 2004
Posts: 117
Likes: 0
Replacing balljoints..Steering knuckle stuck??
Replacing the ball joints on a 2004 F250. Following the FTE directions by raceguy. Everything is going great, but after taking off the ball joint nuts I can’t get the steering knuckle to pop. Any ideas or tricks that might help me. This is where I am. Any help would be greatly appreciated.
Logistics Pro
Joined: Aug 2007
Posts: 3,974
Likes: 18
From: Millersburg, OH
Make sure you hammer the ball joint fork in as far as it will go on both the lower and upper ball joint. If it still doesn't do the trick get a BFH and hit on the knuckle. But really the fork should provide enough of a wedge to pop the knuckle free.
Keep work at it and it will eventually come loose.
Keep work at it and it will eventually come loose.
Thread
Thread Starter
Forum
Replies
Last Post
86F150302
1987 - 1996 F150 & Larger F-Series Trucks
26
Dec 30, 2016 08:25 PM
dancraig
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
8
Aug 14, 2011 10:00 PM
