need help with rims
Thread Starter
|
Posting Guru
Joined: Aug 2000
Posts: 1,849
Likes: 0
From: S.C.
need help with rims
I'm looking at replacing my Torqu thrusts with steel rims & trim. I was looking at vintique 63 series from Jegs $85 ea. They are listed as a Chrysler. are these the same as the old Ford rims, will the ford caps fit.
Thanks
Thanks
Cargo Master
Joined: Sep 2010
Posts: 3,426
Likes: 48
From: Hot AZ (Phoenix Valley)
they show them as out side hubs... I would question them on it? Also look at Hot Rod Steel - 15x6 Primed - Ford - OE Wheels - Wheels . What bolt pattern are you running?
Thread Starter
|
Posting Guru
Joined: Aug 2000
Posts: 1,849
Likes: 0
From: S.C.
Thanks, I'm running 5x4 1/2 I'm also trying not to get unilugs which Jegs carry as bare steel for about $67 each. The ones on hot rods don't list the back spaces or I just don't see it.
Hotshot
Joined: Oct 2009
Posts: 16,172
Likes: 4,772
From: Burbank, WA
The car model doesn't matter as much as the bolt pattern. Most Chrysler products used the same 5 on 4 1/2" bp that Ford cars did, but there were some applictions where they threw a curve ball and also used a 5 on 4 1/4" pattern, mostly on their smaller cars, like the Dart.
