I hope so too, it would be great to see you move into a full size vehicle, lol.

 

tell me about it!!!

 

you should have seen my last rig!! it was a nissan hardbody pickup standard cab!!! that thing was small but man it got great mileage lol

 

Holy crap! Did you use a tub of Crisco to squeeze in there? I know I would have to, lol.

 

lets just say my knees made dents in the dash board lol i bet they are still there lol

 

I found a 77 F150 in great shape on craigslist for $800 sans title, I might go get it and throw the engine from the '79 in there and scrap the '79.

After further investigation this last weekend, it looks like the '79 was rolled at some point and the there is not a panel on the truck without body filler. Not sure what to do at this point?

 

wow..well the 77 sounds nice..i bet you could sell the 79 for close to that in parts maybe..

 

Im sure I could, between the dana 44 and 9", its worth the $800 at least. Im just trying to figure out the most cost effective way to do this.

Edit: As if projects are ever 'cost effective' lol

 

lol very true..have you got the stang running yet?

 

Friday, and a weekend of rest ....after all the partying a week ago....and maybe a bit of honey do stuff is on tap.

 

Not yet, still need to get a timing chain and balancer for the Cleveland, then figure out my serpentine setup for it. I put that on the back burner until the truck is sorted out though.

 

Lunch time! Back in a bit!

 

later man..hurry back its dead on fte today lol

 

It's all just a mind game... as long as you can think it's cost effective, you are good...

 

Okay Im back! Thanks for the insight Rob, oh and BTW, what do you think about my idea from post #96?