Need ideas for mounting Edge CTS Insight gauge
#1
Need ideas for mounting Edge CTS Insight gauge
At the recent dyno day in Spokane I won a 1K gift cert for Edge products. Well the CTS showed up today and its really cool however there is one problem. No where to put it
I have three Isspro's on the pillar and two above the mirror so space is limited. Anyone have any suggestions on where to mount this beast? The main reason I got the Insight was for the backup camera so if I can integrate this into my existing setup that would be nice. I may relocate the 4WD switch
TL,DR: Got free Edge CTS but all ready have 5 gauges
I have three Isspro's on the pillar and two above the mirror so space is limited. Anyone have any suggestions on where to mount this beast? The main reason I got the Insight was for the backup camera so if I can integrate this into my existing setup that would be nice. I may relocate the 4WD switch
TL,DR: Got free Edge CTS but all ready have 5 gauges
#2
Good deal on the certificate from the Dyno Day! I wish I could have made it over there.
I have looked at deleting the air vent above the headlight switch and trimming it out to insert a device like the Edge. That vent does supply air, but on mine I rarely use those vents anyway. Have a back-up camera there would be nice as it is close to the mirror.
I have looked at deleting the air vent above the headlight switch and trimming it out to insert a device like the Edge. That vent does supply air, but on mine I rarely use those vents anyway. Have a back-up camera there would be nice as it is close to the mirror.