roll cage pics
Thread Starter
|
Elder User
Joined: Mar 2004
Posts: 976
Likes: 2
From: clinton iowa
roll cage pics
just thought i'd post some pics of my truck,getting ready for race season so had a roll cage built for it,then had to remove in cab tank and used a bronco2 tank and mounted it in between the frame rails.truck is a 74 f 250 
Lead Driver
Joined: May 2007
Posts: 6,993
Likes: 15
From: Costa Mesa, CA
Watch your shins/knees on that bar below the dash... It would hurt!
Not bashing the work at all, but "tight" to me would go behind the dash.
When I cage my '74 supercab I will be cutting out the inner sheet metal and doing my 2" cage and then tacking the inner sheet metal back in. There is TONS of room behind that stuff in these trucks.
My ranger was kind of done this way, minus the putting the inner sheet metal back in as it was going to be a race truck...
Inner skins still there
Cutting begins
Cage tucked
Not bashing the work at all, but "tight" to me would go behind the dash.
When I cage my '74 supercab I will be cutting out the inner sheet metal and doing my 2" cage and then tacking the inner sheet metal back in. There is TONS of room behind that stuff in these trucks.
My ranger was kind of done this way, minus the putting the inner sheet metal back in as it was going to be a race truck...
Inner skins still there
Cutting begins
Cage tucked
Thread
Thread Starter
Forum
Replies
Last Post
broncoderek
1987 - 1996 F150 & Larger F-Series Trucks
18
Dec 5, 2011 11:44 AM
MNbandit
1987 - 1996 F150 & Larger F-Series Trucks
3
Aug 1, 2011 10:21 PM
