Dent repair
Thread Starter
|
Tuned
Joined: Apr 2009
Posts: 339
Likes: 0
Dent repair
Hi folks, doing some dent repair on my slick and had some questions. I have a dent in the cowl, on the drivers side where the "100" emblem would be, just above the drivers fender (1964). Is there any way to get access behind the panel to do hammer and dolly work? Anyone replace this section before that can offer any tips?
Lastly, does anyone repop door skins for these trucks. Thanks
Lastly, does anyone repop door skins for these trucks. Thanks
Posting Guru
Joined: Jan 2002
Posts: 1,836
Likes: 3
From: Elizabethtown, PA
I don't think that is accessible from behind. You probably need to weld some studs on the outside and use a puller to remove that dent.
Door skins are not reproduced, nor are the entire doors. Used is the way to go.
Door skins are not reproduced, nor are the entire doors. Used is the way to go.
