4.6L Windsor Camshaft Timing specifications needed
#1
4.6L Windsor Camshaft Timing specifications needed
Good Morning,
Can somebody please tell me the Camshaft Timing Specifications for a 4.6L Windsor Engine in a 1997 F250?
Inlet opening / closing
Exhaust opening / closing
Valve overlap
Maximum opening point °CRK
Thank you very much for your help and have a nice day,
Monaco
Can somebody please tell me the Camshaft Timing Specifications for a 4.6L Windsor Engine in a 1997 F250?
Inlet opening / closing
Exhaust opening / closing
Valve overlap
Maximum opening point °CRK
Thank you very much for your help and have a nice day,
Monaco
#2
#3
Hi Moto Mel,
Thanks for the answer. Unfortunatley it does not help. I should think about how to ship the Case of Hacker Pschorr Bräu to Virginia Beach.
I do got a Service Manual but it does not give me the informations I'm looking for. Unfortunatley this manual is not showing me the correct timming position of the LH Cam (is showing only the REP Engine) And I don't thrust the Haynes Manual is telling on 2B-9 "Turn the right sprocket (view from front of engine-means LH Side in fact) until its mark is at 11 o'clock then retighten.... by the way left hand cam (passanger side) should be on 12 o'clock.
So I think it's better messure it out to be save in Valve overlapping.
Any outher suggestions? I can send you a picture how the Cam-Position actually is, but it would help if i get one where it should be.
Thanks and Beer is no problem, or better you visit the Octoberfest will shout some Mass
Thanks for the answer. Unfortunatley it does not help. I should think about how to ship the Case of Hacker Pschorr Bräu to Virginia Beach.
I do got a Service Manual but it does not give me the informations I'm looking for. Unfortunatley this manual is not showing me the correct timming position of the LH Cam (is showing only the REP Engine) And I don't thrust the Haynes Manual is telling on 2B-9 "Turn the right sprocket (view from front of engine-means LH Side in fact) until its mark is at 11 o'clock then retighten.... by the way left hand cam (passanger side) should be on 12 o'clock.
So I think it's better messure it out to be save in Valve overlapping.
Any outher suggestions? I can send you a picture how the Cam-Position actually is, but it would help if i get one where it should be.
Thanks and Beer is no problem, or better you visit the Octoberfest will shout some Mass
#4
Thread
Thread Starter
Forum
Replies
Last Post
unlucky2.1_7.3PSD
Excursion - King of SUVs
10
07-19-2016 02:14 PM
07EXPYEL
2007 - 2014 Expedition & Navigator
0
06-07-2016 11:51 AM
nonrev321
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
1
09-15-2012 03:49 PM