What Have YOU Done To Your Truck Today?
#8401
#8403
#8404
Drove the yellow truck to Mexico. The shop I had used previously to charge the A/C was closed, so I found a new shop.
The technician checked the system out, topped it off, and sent me on my way. In and out in about 15 minutes. Charge: 300 pesos. About $15
Sat in the border crossing line for about an hour. Kept an eye on the temp gauge. The needle moved onto the "200" but never past it.
Brought the truck back home and changed the oil and filter. Valvoline VR1 20w50 and MotorCraft filter. Drives well and blows cold.
The technician checked the system out, topped it off, and sent me on my way. In and out in about 15 minutes. Charge: 300 pesos. About $15
Sat in the border crossing line for about an hour. Kept an eye on the temp gauge. The needle moved onto the "200" but never past it.
Brought the truck back home and changed the oil and filter. Valvoline VR1 20w50 and MotorCraft filter. Drives well and blows cold.
#8406
#8409
#8412
Got a JY tailgate to replace my severely dented one and got it painted and installed.
I also got a 80's spare tire carrier and removed the spare tire from the bed and installed it under the gas tank.
Next thing is to work on the bed....not sure if I'm going to be able to tackle that or not. But we'll see.
I also got a 80's spare tire carrier and removed the spare tire from the bed and installed it under the gas tank.
Next thing is to work on the bed....not sure if I'm going to be able to tackle that or not. But we'll see.
#8413
Got a JY tailgate to replace my severely dented one and got it painted and installed.
I also got a 80's spare tire carrier and removed the spare tire from the bed and installed it under the gas tank.
Next thing is to work on the bed....not sure if I'm going to be able to tackle that or not. But we'll see.
I also got a 80's spare tire carrier and removed the spare tire from the bed and installed it under the gas tank.
Next thing is to work on the bed....not sure if I'm going to be able to tackle that or not. But we'll see.
That bed panel doesn't look too bad, and would probably be a good learning experience. Or you could just call it a "character line"
#8414
Repaired the ever failing linkage from the outside drivers door handle to the latch. Rednecked the door latch post with some garden hose and vinyl tape to tighten up the junction (only temporary). Replaced the vacuum pull off for the choke. Finished the day with some beers and elbow grease on the front clip.
#8415