I may have an opportunity to offer a weekend sheet metal rust repair patch fabrication and installation class this summer in Raleigh NC.
Is there anyone here who would be interested in attending? I have no information on when or how much yet, it's still in the embryo planning stage, but it would be reasonable.

 

Ax,
WOuld it be advanced level or beginner level? If beginner I have interest.

 

wish i was closer !!!!!!!!!!!!

 

If entry level, I would be interested. Let me know dates.

 

I can let you know after I see the dates, have to see what my work schedule is and if I could get off.

 

Location keeps me from attending but I am sure interested in learning. If you made it available in a DVD I'd buy it.

 

Chuck,

I would be interested in making another trip down for your class.

 

I would be interested if I was closer.

 

I would be covering basic metal forming using primarily hand tools available and affordable to the home shop. This would not be in my shop, but rather at TechShop.

 

I think the DVD thing is a great idea!

It wouldn't be expensive to record or to produce, either.

 

ditto on that DVD idea!

 

I should be in NC (Cary and Southern Pines) some time in July so I'd be interested.

 

I'm interested. Need more details though. Can I bring some oil canned panels as an extra credit project?

 

I'll be needing some rusted and/or damaged panels to demonstrate repair techniques on. An oil canned panel to shrink out would be a great project. Chasing the shrink is a bodywork technique, not running after a psychiatrist!Just don't bring me a bed side to flatten, that can take several days alone! Unless you want the stretched panel cut out and replaced, which is what I would likely do.

 

Hey Ax,

Sounds good. Keep me informed I am about 6 hrs or so from there

Jim G 1098