I been hunt at all junkyards expect 1 junkyard which is private.

They are bends due forklift but private junkyard don't have bend and they just push with tractor that good but bigger problem

Driveshaft on SBC 90's F350 with crane have 2 piece of driveshaft Transmission is E40d.

And they have millions of DHL Vans. It look small than F350's driveshaft but want know it will fit or not? They are E250 with V8 5.4L

Or how hard to convert 1 piece of driveshaft to 2 pieces?

 

The driveshaft is probably worth 25 lbs.

Sorry, couldn't resist.

Sounds like you need to get out a tape measure.

 

yu just have to find the correct length shaft. then u joints to make it work. Im using a 1978 rear shaft in my 88 only thing i needed was a u joint that i looked up on parts amrica to get the dimensions