Can anyone tell me or point the way(besides down) lol where to find wheel base and how wide the wheel track is on the ranger or BII is? To give ya'll in idea what I'm doing or distroying. I got a few units in trade when a dealer bought my 02 supercrew. 1. 1979 supercab shortbed needs 351 or 400M motor replaced. 2. 63 falcon 2dr with no drive train. The falcon is what I'm looking to put a rolling frame under. My 66 short wide bed has a new 302 roller motor in it that I want to put in the falcon. BTW the 66 is getting a new 460 efi and F250 frame and susp swapping short wide with short stepside and will pull a long stepside trailer. Back to the falcon. it mesured cinter or tire to tire at 55" and front axle to rear at 110".I could be off just a little with a one man tape. lol Also I worked heavy const as a cert. welder so fab is with-in my bounds. I think. lol

 

My 87 extend cab ranger wheel base is 125", BroncoII is 94" and I belive a regular cab long bed is 113 or 114

 

Thanks. The wheelbase will be a fab but do you know how wide it is? from left tire to right?

 

I belive the axles are like 60" I know that the front ends are 6" shorter then a full size

 

What year Ranger are you curious about?

 

I don't have a year in mind yet but hoping the info will tell what would work the best.

 

I don't have any dimensions but the 93+ ranger/explorers are a little bit wider than the 83-92 ranger/bronco II's.