King pins and u-joints
#1
King pins and u-joints
Well my poor truck needs some loving. I need to replace all the u-joints from front to back and carrier bearing. The front end needs new steering stabilizers and traction bar bushings. Basically front end completely redone.
I called around to several shops and found one that will do the job for roughly $1400.00 They use Splicer and Dana parts which I believe are factory parts??
I also have a friend that said he would charge me $500.00 but I have to buy all the parts. Which I would use Moog and National as my parts. The part would cost roughly 1400.00 SO the total would be $1900.00
Is Moog that great of a product or is Splicer and Dana that not good of a product?
I called around to several shops and found one that will do the job for roughly $1400.00 They use Splicer and Dana parts which I believe are factory parts??
I also have a friend that said he would charge me $500.00 but I have to buy all the parts. Which I would use Moog and National as my parts. The part would cost roughly 1400.00 SO the total would be $1900.00
Is Moog that great of a product or is Splicer and Dana that not good of a product?
#2
Thread
Thread Starter
Forum
Replies
Last Post
ADSf100
1967 - 1972 F-100 & Larger F-Series Trucks
4
05-29-2003 10:20 PM
ST_Wilson
Clutch, Transmission, Differential, Axle & Transfer Case
2
11-13-2002 12:21 PM
sparky
1973 - 1979 F-100 & Larger F-Series Trucks
2
10-30-2002 08:44 PM