P1000 - Evap monitor doesn't complete
#1
P1000 - Evap monitor doesn't complete
I am working on a 2005 F-150 with a 5.4L 3V engine. I had the battery disconnected doing some other work and now the Evap monitor will not complete and keep getting a P1000
I have followed the drive cycle instructions and all the monitors have completed except the Evap monitor.
Ford Motor Company Driving Cycle
any ideas what would cause it to fail?
I have followed the drive cycle instructions and all the monitors have completed except the Evap monitor.
Ford Motor Company Driving Cycle
any ideas what would cause it to fail?
#2
#4
#5
Unless you have an impending emissions test, don't worry about it. Even then, most jurisdictions allow one or two incomplete monitors, check local regulations.
Download a copy of the OBDII book for 2005 at http://www.motorcraftservice.com/vdi...f/OBDSM508.pdf The EVAP testing section starts on page 15 and runs for 20 pages.
Download a copy of the OBDII book for 2005 at http://www.motorcraftservice.com/vdi...f/OBDSM508.pdf The EVAP testing section starts on page 15 and runs for 20 pages.
Thread
Thread Starter
Forum
Replies
Last Post
Frankie4fingers
1968-Present E-Series Van/Cutaway/Chassis
4
06-20-2019 11:52 AM
Tall cold Miller
1999 to 2016 Super Duty
10
06-08-2017 03:56 AM
spckatnip
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
13
01-02-2006 11:09 PM