I am wanting to put a 80mm turbo on my V10 and build the motor with forged rods and pistons as well as doing fuel and oil upgrades and 48lb injectors to make around 600 hp to the wheels. Everything else after parts will be custom piping for the manifolds and intercooler. I have been looking at doing this for awhile now and have red up on what others have done to theirs as far as turbo setups and no one has done a large turbo setup like this yet. I already have a pretty well known truck and would like to take it to the next level and do a big turbo setup.
I need help with what turbo to go with. A guy at my shop recommended a GTX4202R turbo for what I am aiming for. I also need to figure out what wastegate size I should go with, was thinking a 66mm? As for the injectors I think 48lbs would be the right amount needed. I don't know much about engines so anything that can help me figure out what all I need to do would be great!
You could get the same results with an r trim centrifugal blower. They can put out over 30psi of boost and it would be 1000 times less of a headache than trying to pipe a 10into 1 manifold and with a fully built motor you'd be looking at at least 600 but probably closer to 8.