ScanGaugeII or truck problems
#1
ScanGaugeII or truck problems
Purchased a ScanGauge and put it into my F250. Programmed the XGauge to read a few of the parameters.
The EOT does not provide a reading.
The EGR position reads "0"
and a couple other values didn't register either (don't remember off the top of my head which).
Just looking for thoughts, is this a truck or ScanGauge problem? (Before someone says "User problem" , I verified that my input numbers were correct.) I had also planned on asking what values I should be looking for but Rusty listed those in another thread--THANKS!
The EOT does not provide a reading.
The EGR position reads "0"
and a couple other values didn't register either (don't remember off the top of my head which).
Just looking for thoughts, is this a truck or ScanGauge problem? (Before someone says "User problem" , I verified that my input numbers were correct.) I had also planned on asking what values I should be looking for but Rusty listed those in another thread--THANKS!
#3
Thread
Thread Starter
Forum
Replies
Last Post
opie2
Fuel Injection, Carburetion & Fuel System
16
08-21-2005 10:39 PM