'62 F100 body mount bushing (rubber) height
#1
'62 F100 body mount bushing (rubber) height
Afternoon fellow '60's Forders,
I am new to posting but have been greatfully reading everyone's advice on FTE for years and I kinda have myself in a pickle, I need to know how thick the body mount bushing rubbers are supposed to be as my helpers decided to throw away the originals . I have a set of new ones for a different breed that I had given to me but I know they are too short. I have a '62 2wd short box that I did the 03 crown vic swap pics here Facebook
Any help would be greatly appreciated
JasonRS
I am new to posting but have been greatfully reading everyone's advice on FTE for years and I kinda have myself in a pickle, I need to know how thick the body mount bushing rubbers are supposed to be as my helpers decided to throw away the originals . I have a set of new ones for a different breed that I had given to me but I know they are too short. I have a '62 2wd short box that I did the 03 crown vic swap pics here Facebook
Any help would be greatly appreciated
JasonRS
#3
The front top bushing is 1 inch. The front bottom bushing is 9/16. The metal sleeve that runs through them is 1 21/64 in length.
The rear top bushing is 1 1/4. The rear bottom bushing is 1/2. The sleeve is 1 51/64.
These were taken directly from a new Dennis Carpenter repro set.
Hope this helps - p38fighter
The rear top bushing is 1 1/4. The rear bottom bushing is 1/2. The sleeve is 1 51/64.
These were taken directly from a new Dennis Carpenter repro set.
Hope this helps - p38fighter
Thread
Thread Starter
Forum
Replies
Last Post
Hotairjunkie
1968-Present E-Series Van/Cutaway/Chassis
3
09-30-2022 09:52 PM
AstroFab
1948 - 1956 F1, F100 & Larger F-Series Trucks
9
01-11-2011 11:20 PM