S&B intake on 6.4 question
#1
S&B intake on 6.4 question
I just got my S&B intake delivered the other day. I opened the box and was surprised to see it's in like 50 pieces. (maybe an exaggeration) I thought it would of been more assembled. Anyone that has one of these on their 6.4, how long does it take and how much of a pain in the @$$ is putting one of these on? I also got my XRT pro in and my down pipe back exhaust. I'm trying to figure out if I should do everything at once, or do the intake on a different day.
#2
#3
Same here it takes about 30 minutes.
Do not and I mean DO NOT use the thread locker if your kit came with it. When you tighten with the trhead locker the next day the acrylic piece will crack.
S&B sent me a replacement and said early kits came with the locker tube. For some reason it tightened up more when heated up and the cracks came.
Do not and I mean DO NOT use the thread locker if your kit came with it. When you tighten with the trhead locker the next day the acrylic piece will crack.
S&B sent me a replacement and said early kits came with the locker tube. For some reason it tightened up more when heated up and the cracks came.
#5
Thread
Thread Starter
Forum
Replies
Last Post
smash fascism
1994.5 - 1997 7.3L Power Stroke Diesel
3
04-18-2011 12:32 PM
bobpearson90278
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
4
01-21-2008 08:06 PM