Looking for Headers
#1
Looking for Headers
All,
I just purchased a 1955 F-100 with a 429 Ford and C6 automatic. I am looking for a set up headers that will work on this combination. If anyone has brand/part number that would be great. Just in case is also has a Mustang front end under it already, if that is needed to know for clearance issues.
Thanks,
Pat
I just purchased a 1955 F-100 with a 429 Ford and C6 automatic. I am looking for a set up headers that will work on this combination. If anyone has brand/part number that would be great. Just in case is also has a Mustang front end under it already, if that is needed to know for clearance issues.
Thanks,
Pat
#2
#4
here are a couple pics..
the key measurements on the driver side
on the rear pipe, from flange face at the head to the furthest distance away from the face, 5 inches.
face to the nearest part of the collector, 1.5 inches.
from the center of the rear bolt, to the lowest edge, 8 inches.
the rear pipe comes straight down.
no idea what they were originally for..
my engine came out of a 69 mustang fastback
Sam
the key measurements on the driver side
on the rear pipe, from flange face at the head to the furthest distance away from the face, 5 inches.
face to the nearest part of the collector, 1.5 inches.
from the center of the rear bolt, to the lowest edge, 8 inches.
the rear pipe comes straight down.
no idea what they were originally for..
my engine came out of a 69 mustang fastback
Sam
Thread
Thread Starter
Forum
Replies
Last Post
thesprocket26
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
4
06-28-2004 09:06 AM