You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
How do you like it? I have an Edge Insight which allow me to view codes and monitor temps. I believe the software allow you to do diagnostics and testing. Has it been useful?
Sorry David...I unsubscribed from this thread a while back and didn't realize until now that you had replied to it.
I'm getting the hang of the AE software a little more each time I use it. No doubt it's capabilities are still far beyond mine, but I'm glad I bought it.
Sorry David...I unsubscribed from this thread a while back and didn't realize until now that you had replied to it.
I'm getting the hang of the AE software a little more each time I use it. No doubt it's capabilities are still far beyond mine, but I'm glad I bought it.
Hi and thanks for following up!
I did buy the AE software but I haven't had time to play with it much. I did run the injector test and found they were all contributing equally which is good to know. I think I can read the strategy code so that is the next project.
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.
