When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
In the JY the other day and saw a diaphragm looking thing attached to these two holes on the driver side fender support. Didn't spend much time tracing the hoses on it but was curious as to what it was.
Same setup was used on the older trucks as well. My '82 F150 has the Cruise control mounted there as well. The 351M or 460 I cant remember which one it was but they had the cruise control mounted on a tri bar tube bracket on the back side of the intake manifold. I believe I still have the bracket I took off as it was being removed as it didn't work.
Must have been then. I didn't put the engine in it just did the brakes on it and knew it was either a M or a 460 but wasn't fully sure. Havent really seen many 460s in person to know the look just yet.
My 460 and my 6.9 both had the cruise in that location as well. Wasn't either of those.
Perhaps it was a dealer or aftermarket cruise setup and not factory?