Conversation Between 410F-100 and 1997f1504X4,4.6L

Ok, I am located in Glenrock Wyoming.
Looking at 800 for the van, 200 for the weiand manifold, and 300 if you want my edlebrock carb.
The van has a fuel injection kit in it, but the computer had gone bad and would need a new computer if you would rather go the fuel injection route. The kit is included in the van and is all there
If you would like pix hook me up with your email,I can probly even make a Vid of the engine running so you can hear that there are no tappsknocks or no smoke if you would like
Let me know and Ill need to know if you dont want the whole van Ill see what it takes to dispose of it before you make the tripp.
I just figured that you would cuas it would have everything you need for the 351W swap.

ok drop time lol what do u want for it? maybe we can work a deal and where are u located?

Well you dont have to take the van with you, like I said You could just haul it up to our local dump if you dont want it... I just cant start parting another vehicle...
The tranny shifst great, no problems there. there is a slight vacume leak somewhere on the intake manifold, but I have a new weiand stelth manifold and gaskets to fix the vacume leak, its just hard to pull the manifold beacuse of how enclosed it is, and where the trubo sits... Would be loads easier to fix if it wernt for the difficult access...
The engine runs great untill it warms up ten the leak opens up and has an iratic idle...
has only 94,000 miles, and the turbo has only been around for about 20,000 miles or so. Turbo was replaced about 1,000 miles or so ago...

Still intrested in my turbo 351W???

You will have to haul away the whole van too (even if it was just up to the local dump...), just beacuse the land people allredy dont like how many vehicles I have, and they would **** a brick if I started to part out another vehicle!!!
Shoot me an offer and we can go from there...

how much are we looking at for the turbod 351 and transmission dude? very intrested