Conversation Between smoky_diesel and lindner115

Hi,
the math (distance) and direction of the holes is in the thread. I think moving one hole 0.200" is about 2 degrees. that said you can't really move the hole more than 0.400".

Hey Lindner115 again, sorry to bother you again. I was wondering after looking at all the aftermarket radius arms, they only slot lower hole. Can i get away with doing this only? i am putting the truck on alignment rack tomorrow to get rock solid caster number. Would like to get to the 4 degree area. Say i'm at 1 degree positive, how far in what direction do i slot to gain 3 degrees? Does this make any sense.

Hey i seen your right up on modifying your radius arms on f350. I've got same issue and am throwing around doing that. Was it much a job to get them out? The top hole goes forward and bottom goes back, it that correct or other way around? How far did you go about a 1/4"? thanks.