Question regarding 2003-2007 Crown Vic IFS
Thread Starter
|
Freshman User
Joined: Apr 2007
Posts: 35
Likes: 0
Question regarding 2003-2007 Crown Vic IFS
I have read the tread on the 67-72 forum where they are utilizing crown vic IFS which is an aluminum bolt in cross member and wonder if anyone in the pre 47 era trucks has tried this. The measurements are close to the same track width as my 47, but the later trucks have a wider frame width.(34" vs 32") The measurement they have provided put the bolt holes just at the edge of the outside frame width. Just though I would check as I was looking at the jag ifs still as well.
Thread
Thread Starter
Forum
Replies
Last Post
HkyswiM
1948 - 1956 F1, F100 & Larger F-Series Trucks
21
Feb 17, 2021 12:11 PM
bassn1
1948 - 1956 F1, F100 & Larger F-Series Trucks
8
Dec 30, 2014 10:56 PM
fearsome
1948 - 1956 F1, F100 & Larger F-Series Trucks
6
Jan 20, 2014 04:50 PM
Greg55_99
1967 - 1972 F-100 & Larger F-Series Trucks
8
Apr 14, 2009 04:36 PM
I_am_fishbait
1961 - 1966 F-100 & Larger F-Series Trucks
2
Feb 3, 2007 04:20 AM
