Need stock crankshaft pulley
Thread Starter
|
New User
Joined: Nov 2006
Posts: 16
Likes: 0
Need stock crankshaft pulley
Hello...I'm looking for a stock crankshaft pulley for a 1945 Flathead V8. The motor is an industrial motor that ran a sawmill. I'm putting it into my '46 1/2 ton pickup but it needs a pulley. What is on there now is the steel inner pulley to run the water pumps and generator but the outer cast iron pulley is a smaller one that ran a generator mounted to the industrial motor frame. It doesn't extend out enough to line up with the fan. Were they two crankshaft pulleys or is it all one piece (two flanges). Advice would be very appreciated. Tim
Senior User
Joined: Dec 2004
Posts: 182
Likes: 0
From: Wild Wonderful WV
Call joblot automotive in New York.
JobLot Automotive
I got a double sheave crank pully from them, runs about 80 bucks I think.
JobLot Automotive
I got a double sheave crank pully from them, runs about 80 bucks I think.
Senior User
Joined: Dec 2004
Posts: 182
Likes: 0
From: Wild Wonderful WV
