Edelbrock Auto Choke Install
Thread Starter
|
Senior User
Joined: Jan 2004
Posts: 284
Likes: 1
From: North Carolina
Edelbrock Auto Choke Install
OK, I guess I'm stupid. I've installed an automatic choke on my 1407 and I'll be darned if I can understand the Edelbrock instruction sheet. I guess I'm the only dufus on the planet but I seriously think they could do better than this with instructions and drawings.
<Rant Over>
I searched this forum and didn't see it if it already exists but does anyone know where there are better instructions for the configuration of this thing after it's installed to the carb main body.
The side of my choke housing where they say put the little wire looks nothing like the picture (at least with the cap installed).
I'm also short on the part name knowledge so an appendix or a drawing with little arrows pointing to linkage X and screw B would be nice. :-)
I need some "See SpotRun" kind of thing. LOL
<Rant Over>
I searched this forum and didn't see it if it already exists but does anyone know where there are better instructions for the configuration of this thing after it's installed to the carb main body.
The side of my choke housing where they say put the little wire looks nothing like the picture (at least with the cap installed).
I'm also short on the part name knowledge so an appendix or a drawing with little arrows pointing to linkage X and screw B would be nice. :-)
I need some "See SpotRun" kind of thing. LOL
